The link on the bottom of this page will take you to an interactive programming guide for standard PLC/HMI controls for TableTop PulseSealer without customization. The custom unit specifically designed for ITW Insulated Products uses a slightly different format as shown in the photo below. This modification provides separate heat controls for upper and lower sealing bars.
As you view the following screenshots, note that your screenshot includes two setting groups for each material (as shown above). Settings for Upper Sealing Bar (Top) and Lower Sealing Bar (Bottom). Settings will be described in following pages, however it is important to note that the sequence of operations used for your machine when “Both” is selected in SETUP menu is: Note that if “Both” is not selected, then either only the Upper or Lower Sealing Bar will provide heat.
Upper Sealing Bar PLS 1 ON; Lower Sealing Bar PLS 1 OFF
Upper Sealing Bar P-WDTH ON; Lower Sealing Bar PLS 1 OFF
Upper Sealing Bar PLS 2 ON; Lower Sealing Bar P-WDTH OFF
Upper Sealing Bar P-WDTH ON; Lower Sealing Bar PLS 1 ON
Upper Sealing Bar P-WDTH ON; Lower Sealing Bar P-WDTH ON
Upper Sealing Bar P-WDTH ON; Lower Sealing Bar PLS 2 ON
Upper Sealing Bar P-WDTH ON; Lower Sealing Bar P-WDTH ON
Upper Sealing Bar P-WDTH ON; Lower Sealing Bar P-WDTH ON
Upper Sealing Bar P-WDTH OFF; Lower Sealing Bar P-WDTH ON
Upper Sealing Bar P-WDTH OFF; Lower Sealing Bar P-WDTH OFF
Cycle completes and Upper Sealing Bar returns to Upper Position
In the example, as shown in the Screenshot, above, total lapse time would not exceed 150 seconds, based on concurrent operations.
